Taylor-Dunn MX6-00, Инструкция по эксплуатации и устранению неисправностей

Страница: 92 / 200

ELECTRICAL TROUBLESHOOTING
SECTION 4 Main Sequence PAGE 14
Connect a voltmeter across the COLD terminal
of the key switch and battery negative.
Turn the key switch ON.
•
If the voltage is not at battery volts then
the key switch has failed. Stop trouble
shooting here and repair the problem.
When the repair is completed,
completely retest the vehicle before
lowering the drive wheels to the ground.
•
If the voltage is at battery volts but the
previous test at pin #4 in the Accelerator
section failed then check the wire from
the key switch to pin #4 at the accelerator
module. Stop trouble shooting here and
repair the problem. When the repair is
completed, completely retest the vehicle
before lowering the drive wheels to the
ground.
For your reference, shown at the right are the
Forward and Reverse switch wire connections
for a typical control system.
Connect a voltmeter across the HOT terminal of
the KSI side of the F&R switch and battery
negative.
Turn the key switch ON.
•
If the voltage is not at battery volts then
go to the
Accelerator sequence.
The HOT terminal is the Violet/Black
wire on the center terminal
Battery Negative
"COLD, Violet Wires(s)"
"HOT, Red wire(s)"
BATTERY MAIN NEGATIVE
KEY SWITCH
View of the terminals of a
typical Key Switch
A
OFF
mV
V
V
Hz
FLUKE 79
SERIES II MULTIMETER
Violet/Black
Forward and Reverse Side
Typical configuration of the
terminals on a Forward and
Reverse Switch as viewed
from the back
KSI Side
Blue/Black
Green/Black
White/Black