Taylor-Dunn MX6-00, Инструкция по эксплуатации и устранению неисправностей

Страница: 72 / 200

3-48
SECTION 3
SS5-34 Motor Removal
1. Park the vehicle on a level surface and block the wheels to prevent
movement. Disconnect the batteries.
2. Remove the deck board and place it out of the way.
3. Mark the wire leads on the motor to insure their proper location
when reinstalling the motor.
4. Remove the wire leads from the motor and loosen the motor mount
clamp.
5. Loosen the motor adjusting bolt lock nut and turn the adjusting bolt
until the belts can be easily removed.
6. Remove the belts.
7. Remove the four motor mounting bolts from the face of the motor.
8. Remove the motor assembly from the vehicle.
9. Install in reverse order and adjust the belts using the appropriate
procedure.
Brushes
The motor brushes must be checked regularly for wear. Use the following procedure
to check the brushes in the motor for wear:
1. Remove the motor from the drive assembly.
2. There is a small inspection hole above each of the four brushes.
Insert a .035” rod or paper clip into the inspection hole until it
contacts the top of the brush. Mark the rod and measure how far it
was inserted into the motor.
3. If the rod travels into the hole 1.5” or more, then the brushes must be
replaced. Inspect all four brushes.
NOTE: We recommend that all the brushes be replaced at
the same time.