Taylor-Dunn MX6-00, Инструкция по эксплуатации и устранению неисправностей

Страница: 87 / 200

ELECTRICAL TROUBLESHOOTING
SECTION 4 Main Sequence PAGE 9
Motor
Set the test light voltage to the same voltage as
the battery volts.
Connect the test light across the motor ‘A1’ and
‘A2’ terminals.
Close all interlock switches, turn the Key
Switch ON, and place the F&R Switch in
Forward.
Depress the accelerator fully.
•
If the light comes on then the motor
armature windings are open and the
motor must be repaired or replaced. Stop
trouble shooting here and repair the
problem. When the repair is completed,
completely test the vehicle before
lowering the drive wheels to the ground.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
The rear drive wheels may rotate during some of the following tests.
Block the front wheels, raise the rear drive wheels off the ground,
and support the vehicle with jack stands. Failure to do so may cause
the vehicle to move and cause property damage and/or serious bodily
injury.
Rotating rear drive wheels are a potential hazard. Keep hands, arms,
legs and loose clothing away from the rear drive wheels while
conducting tests. Failure to do so may cause serious bodily injury.
Motor shown for reference only. Terminal positions
on your motor may not be in the same location.
S2
A1
A2
S1
Wiring to motor omitted for clarity. Do not
disconnect the motor wires for this test.