Taylor-Dunn ET 3000, Руководство пользователя

Страница: 29 / 216

Safety Rules and Operating Instructions
Page 15
MB-T48-02
T-48 AC / ET 3000
72-volt equipped with 30:1 drive ratio
Acceleration Parameters (normal mode)
Function Value Unit Description
FwdAS LS 3.2 S
Time to accelerate to ~15% of full
speed
FwdAc HS
3.2
S Time to accelerate to full speed
RevAc LS 5.2 S
Time to accelerate to from FwdAC LS
to full
RevAc HS 5.2 S Time to accelerate to full speed
Acceleration Parameters (low speed mode)
FwdAS LS 4.0 S
Time to accelerate to ~15% of full
speed
FwdAc HS 4.0 S Time to accelerate to full speed
RevAc LS 5.0 S
Time to accelerate to from FwdAC LS
to full
RevAc HS 7.4 S Time to accelerate to full speed
Deceleration Settings
Brake Multiplier 50 %
Brake regen multiplier is activated by
the brake switch
Normal Decl HS 8.0 S
Time to decelerate to 0 when above
20% of full speed
Normal Decl LS 8.0 S
Time to decelerate when below 20% of
full speed
Tow Decl HS 9.5 S
Time to decelerate to 0 when above
20% of full speed
Tow Decl LS 11.0 S
Time to decelerate when below 20% of
full speed
Maintenance Meter Function
Service Timer
0
H
Refer to Maintenance Meter supple-
mentary manual
Speed Limits
Max (see warning) 5,900 RPM Governed speed (see formula)
Tow 50 %
Percentage of Max speed when Tow
Switch is ON
Rev 50 %
Percentage of Max speed when in
reverse
Low Batt 40 %
Percentage of Max speed when low
battery warning is ON
Service Due 25 %
Percentage of Max speed when service
is due. See maintenance Meter Function
Battery Characteristics
Full Volts 2.165 V
Battery must exceed this voltage to be
considered fully charged
Empty Volts 1.730 V Voltage of a fully discharged battery
BDI Level for Batt Spd 15 %
Low battery warning is ON when bat-
tery is discharged below this level
BDI Reset %
80
%
Battery must be discharged below this
value before the BDI will be allowed
to reset
Reset Volts 2.1 V
Battery voltage must be above this
value to reset the BDI. Modified by the
‘BDI Reset %’ above)
Discharge Time 60 M Estimated battery discharge rate
Miscellaneous
SRO Min Speed 2,000 RPM
Motor must be below this RPM to
change directions with the throttle pedal
depressed