Taylor-Dunn ET 3000, Руководство пользователя

Страница: 32 / 216

Safety Rules and Operating Instructions
Page 18
MB-T48-02
T-48 AC / ET 3000
Taylor-Dunn X-Series Charger
The X-Series chargers are designed as automatic chargers. The charger turns itself on when it is plugged
into the wall outlet and turns off when the batteries are fully charged.
There is a user interface on the charger. The interface consists the following:
• Ammeter: Indicates the current flowing into the battery during the charging cycle.
• Start/stop switch: When depressed, the charging cycle will be terminated or restarted.
• Low voltage start switch: When depressed, will start the charge cycle if the battery voltage is too low
for an automatic start.
• Self diagnostic switch: Starts the charger self diagnosis procedure.
• Charging status light: Indicates the current status of the charging cycle. The light will start flashing
when the charging cycle is started. It will stop flashing and remain ON when the cycle has completed.
Also used for fault indication along with the fault light.
• Fault light.: Displays faults after self diagnosis is completed.
Self Diagnosis Procedure
If you suspect a battery charging problem press the self diagnostic switch to start the charger self diagnostic
procedure. Any faults found by the procedure will be displayed by the two LED’s. Refer to the table below
for the fault codes.
Note: To run this procedure, a battery that is not severely discharged must be connected to the charger.
Fault LED Status LED Action Required
OFF OFF • No faults found.
Flashing Flashing
• Battery voltage either too high or too low. Confirm that the correct
battery and charger is installed in the vehicle.
• Faulty battery, will not accept a charge.
• Battery installed is too large (Amp Hours).
ON OFF or Dim • * Faulty charger
Flashing ON • * Faulty charger
ON Flashing
• ** AC input voltage is out of range. Confirm that the AC outlet has
the correct voltage for the charger.
• *Charger circuit breaker tripped. Reset the breaker by pushing the
button. If the fault reoccurs, then i t indicates a faulty charger.
ON ON • *Faulty charger.
Flashing OFF • ***Charger programmed incorrectly.
* Refer charger repair to a qualified technician
** Only a qualified electrician should check the AC line voltage.
***
Continued use of the charger may damage your batteries. Refer charger repair to a
qualified technician
This charger is rated for 115 VAC or 230 VAC operation (nominal). Confirm
the charger installed is correct for the AC voltage power source before
connecting the charger.
Sealed batteries must be charged with a charger configured for sealed
batteries. Use of any other charger will result in damage to the batteries
and premature failure of the batteries.
CAUTION