Taylor-Dunn C0-425-36, Инструкция по эксплуатации, устранению неисправностей и замене компонентов

Страница: 56 / 246

Maintenance, Service, and Repair
Steering Page 2
FRONT END ALIGNMENT
Inspection, Axle Centers
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
6. Raise the front of the vehicle and support with jack stands.
7. Measure the distances from the rear of the lower axle beam to the rear wall of the wheel well on
both sides of the axle beam next to the steering knuckle. Adjust the lower suspension links so
that the distance is between 10-1/8 to 10-3/8 inches.
NOTE: The difference between the left and right measurement should be
no more than 1/8 inch.
8. Measure the distances from the rear of the upper axle beam to the rear wall of the wheel well on
both sides of the axle beam next to the steering knuckle. Adjust the upper wishbone link so that
the distance is 1/2 inch less than the lower measurement.
NOTE: Do not continue with the front end alignment until the axle centers
are properly adjusted.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Unplug the main battery connector.