Taylor-Dunn C0-425-36, Инструкция по эксплуатации, устранению неисправностей и замене компонентов

Страница: 28 / 246

SAFETY RULES AND OPERATING INSTRUCTIONS
Safety Rules Page 10
Smart View Display
Key Hours icon
The Smart View Display (SVD) functions as a Battery Status Indicator (BSI), Hour Meter (HM), speed
controller status monitor, and as an optional maintenance monitor feature. The operation of each of
these functions is listed below.
BSI : A bar graph representing the current state of charge is located across the top of the display. When
the batteries are fully charged, all segments of the bar graph will be on. As the batteries are used,
segments will turn off in the order of right to left.
When the batteries are discharged to 75%, the last three segments will flash indicating that you are
approaching the end of the battery cycle. At this time, the vehicle’s batteries should be charged as soon
as possible.
At 90%, all segments will flash and the vehicles speed will be reduced. At this time, the vehicle should be
removed from service for charging. Discharging beyond 90% will result in damage to the batteries that
will shorten the battery life-span.
HM: There are two hour meter functions, Key Hours and Run Time Hours.
Key Hours is the accumulated length of time in hours that the key switch is in the “ON” position.
Run Time Hours is the accumulated length of time that the vehicles has been in operation. Time is
accumulated when the FS-1 switch in the accelerator module is closed.
One of the Hours functions is being displayed whenever the either of the Hours Indicators are visible at
the right side of the display.
Key Hours: When the display is turned on, the
Key Hours will be displayed for approximately 5-
seconds as indicated by the Key Hours Indicator
located at the lower left of the display. The icon
represents the silhouette of a key.