FITTING OPTION 1
1.
Determine the correct position and orientation for the shower and screw the cranked connectors (2) into
the appropriate water supplies finished with a ½” BSP female adapter (not supplied). Hot on the left, cold
on the right with outlet positioned on the underside of body with SKN0601 or on the top of the body with
SKN0706.
2.
Screw the shrouds/flanges (1) onto the cranked connectors.
3.
To fit the body onto the wall, place the washers (3) into the connecting nuts (4) and tighten to the cranked
connectors (2). The connecting nuts (4) are secured to the mixer body by the retaining nuts (5). Note: No
back nuts or fixing plates are supplied. This shower valve is clip mounted it needs to be connected to and
supported by rigid pipe work.
TROUBLE-SHOOTING
If you require further assistance beyond the guide below contact the help line on 01225 303 900
AFTERCARE INSTRUCTIONS
Whilst this item has a high quality durable finish, it should nevertheless be treated with care. Surfaces should
be cleaned using only a soft damp cloth and clean water & dried using a soft cotton cloth. Bath / shower
cleaning products, even non-scratch ones could damage the finished surface.
MAINTENANCE
We advise that the valves, check valves and filters be regularly serviced particularly in hard water areas. The
check valves along with the filters are contained in the retaining nut. The water supplies must be isolated
remotely from the valve before removal. To access the check valves unscrew the connecting nuts joining the
mixer to the cranked connectors. Unscrew the retaining nuts (left hand thread) from the mixer and check their
conditions then reassemble and turn on water supply.
TMV2 approved valves shall be tested against the original set temperature results once a year. When testing is
due the following performance checks shall be carried out.
1.
Measure the mixed water temperature at the outlet.
2.
Carry out the cold fail-safe shut off test by isolating the cold water supply to the TMV, wait for 5 seconds if
water is still flowing check that the temperature is below 46 degrees C.
3.
If there is no significant change to the set outlet temperature (+/- 2°C or less change from the original
setting) and the fail safe shut off is functioning, then the valve is working correctly and no further service
work is required.
If further maintenance should be required contact Tavistock for details. Please see contact details on the back
page of this document.
Problem
Shower will not run hot enough when first installed
Cold water running back through the valve into the hot
water system.
Solution
Maximum temperature needs adjusting, see temperature
setting guide
Check and clean the check valve cartridges and filters
located under the check valves.
1
2
3
4
MAX
cut
diameter = 45mm
KINETIC BOTTOM OUTLET BAR VALVE SHOWN
