After Sales Support
TEL: 1300 922 271 EMAIL: [email protected]
10
3. Layout (Figures 1/2)
1. ON/OFF switch
2. Power cord
3. Rubber tires
4. Web panel
5. Machine foot
6. Extractor socket
7. Lower blade pulley
8. Upper blade pulley
9. Tightening screw
10. Blade guard
11. Upper blade guide
12. Side cover
13. Hood closure
14. Retaining screw for upper blade pulley
15. Saw table
16. Dial scale for tilt angle
17. Plastic table insert
18. Fixing handles for saw table
19. Setting handle for blade guide
20. Fixing handle for blade guide
21. Clip for parallel stop
22. Setting screw for upper blade pulley
23. Motor
24. Parallel stop
25. Machine frame
26. Blade
4. Items Supplied
-
1 x Bandsaw
- 1 x Saw table
- 1 x Push stick
- 1 x Parallel stop
- 1 x Instruction Manual
- 1 x Quick Start Guide
-
1 x Warranty Card
-
1 x Warranty Sticker
- Open the packaging and take our the equipment
with care.
- Remove the packaging material and any packaging
and/or transportation braces (if available).
- Check to see if all items are supplied.
- Inspect the equipment and accessories for the
transport damage.
- If possible, please keep the packaging until the end
of the guarantee period.
Important!
The equipment and packaging material are not toys. Do
not let children play with plastic bags, foils or small parts.
There is a danger of swallowing or suffocating! Do not let
children play with plastic bags, foils or small parts. There
is a danger of swallowing or suffocating.
5. Proper use
The bandsaw is designed to perform longitudinal and cross
cuts on timber or wood-type materials. To cut round materials
you must use suitable holding devices.
The machine is to be
used only for its prescribed purpose.
Any use beyond that mentioned is considered to be a case
of misuse. The user/operator and not the manufacturer shall
be liable for any damage or injury resulting from such cases
of misuse. The machine is to be operated only with suitable
sawblades. To use the machine properly you must also
observe the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the machine have to be
acquainted with this manual and must be informed about the
machine’s potential hazards. It is also imperative to observe
the accident prevention regulations in force in your area.
The same applies for the general rules of occupational health
and safety.
The manufacturer shall not be liable for any changes made to
the machine nor for any damage resulting from such changes.
Even when the machine is used as prescribed it is still
impossible to eliminate certain residual risk factors. The
following hazards may a rise in connection with the machine’s
construction and design:
•
Damage to hearing if ear-muffs are not used as necessary
•
Harmful emissions of wood dust when used inclosed rooms.
•
Contact with the blade in the uncovered cutting zone.
•
Injuries (cuts) when changing the blade. Injury from
catapulted workpieces or parts of workpieces.
•
Crushed fingers.
•
Kickback.
•
Tilting of the workpiece due to inadequate support.
•
Touching the blade.
•
Catapulting of pieces of timber and workpieces.
Please note that our equipment has not been designed
for use in commercial, trade or industrial applications. Our
warranty will be voided if the machine is used in commercial,
trade or industrial businesses or for equivalent purposes.
