Taurus TST16 355, Руководство по эксплуатации

Страница: 7 / 17

CLEANING AND MAINTENANCE
1. Keep the motor-outlet well ventilated and clean. Compressed air can be
used to blow off the dust in the motor.
2. Check the bearing housing and the gearbox periodically and lubricate
them occasionally.
3. After the cutting-off machine has been operated for 40 hours, check the
carbon brush for replacement. The carbon brush should be changed, when
its length is shortened to only 5-6 mm by abrasion (see Figure 3).
4. Disconnect the plug from the power source then remove the brush lid with
a screwdriver for checking and replacing the brush. Take away the worn
brushes, and insert a new pair. Let the motor run for 10 minutes.
Specification of the cutting-off machine
D: Outer Diameter D1: Inner Diameter t: Thickness
Type TS16-355
D0 (mm) 355
Dimension of the
wheel
D1 (mm) 25.4
t (mm) 3.2
Power Voltage (V) 230
Frequency (Hz) 50
Nominal input
capacity
(W) 2000
Idling speed (r/min) 3900
Dimension (mm) 600X330X430
Net weight (kg) 18
Vibration (m/s2) 1.109
Noise (dB(A)) Lp=89.6, Lw=102.6
Max. cutting depth (mm) 90
5
Figure 6
Figure 3