Taurus TST16 355, Руководство по эксплуатации

Страница: 5 / 17

OPERATION
1. Make sure that the supply voltage matches that specified on the
rating plate.
2.
Specifications for abrasive wheel:
Type Outer
Diameter Inner
Diameter Thickness Operating
Linear Velocity
TS16-355 355 254mm 32mm * 80 m/s
3. Use only abrasive wheels in good condition.
4. An abrasive wheel that has been stored for more than one year should be
strength tested. It can be only used after it has passed the test.
5. Before carrying out any work, allow the motor to run idle for one minute.
Make sure there is no oscillation caused by improper installation of the
abrasive wheel. Unusual oscillation may cause unusual noises and the
installation should be adjusted.
6. Secure the work-piece properly with vice before starting to cut. Maintain
appropriate wheel speed by varying the downward pressure applied
during cutting, depending on the profile, material and diameter of the
object being cut.
Adjustment of the vice
The auxiliary stopper of the vice can be tilted to an angle of –30° to 45°.
To Adjust the angle of the vice loosen the two fixing screws on the auxiliary stopper
and tilt it to the desired angle, then tighten the fixing screws again.