Taurus Titanium BT-SM 2534 DUAL, Инструкция по эксплуатации

Страница: 11 / 20

AFTER SALES SUPPORT
1300 922 271 service.australia@einhell.com
11 MODEL NUMBER: BT-SM 2534 DUAL, 12/11
•
Pull out the power plug and twist the blade with
your hand into the 45° and 90° positions in order
to make sure that the blade does not touch the
turntable in any position. If necessary, readjust
the saw head.
•
If the table insert is worn, replace it.
•
Never use blades made of high-speed steel (HSS).
•
When cutting mitres, make sure that the device
for swiveling the arm is fastened securely.
•
Be careful when working in vertical mode.
•
Caution: Take extra care when making double
mitre cuts!
•
Do not overload your tool.
•
Wear safety goggles.
•
Use a dust mask when working on dusty jobs
•
Check the tool cable/extension cable for damage.
•
Always wear gloves when handling saw blades
5. Special Information about the Laser
•
Never look directly into the laser path.
•
Never direct the laser beam at reflecting surfaces
or persons or animals. Even a low output laser beam
can inflict injury on the eye.
•
Caution: It is vital to follow the work procedures
described in these instructions. Using the equipment
in any other way may result in hazardous exposure
to laser radiation.
•
Never open the laser module.
•
When the sliding mitre saw is not going to be used
for an extended period of time, the batteries should
be removed.
•
It is prohibited to carry out any modifications to the
laser to increase its power.
•
The manufacturer cannot accept any liability for
damage due to non-observance of the safety
information.
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety information with due care. Keep these operating
instructions in a safe place so that the information
is available at all times. If you give the equipment to
any other person, hand over these operating instructions
and the safety information as well. We cannot accept
any liability for damage or accidents which arise
due to a failure to follow these instructions and the
safety information.
3. LAYOUT
1. Handle
2. ON/OFF switch
3. Release lever
4. Machine head
5. Saw shaft lock
6. Adjustable blade guard
7. Saw blade
8. Clamping device
9. Removable fence
10. Workpiece support
11. Fixed fence
12. Table insert
13. Adjustable foot
14. Locking screw
15. Pointer
16. Scale
17. Turntable
18. Fixed saw table
19. Scale
20. Pointer
21. Locking screw
22. Sawdust bag
23. Slide guide
24. Slide lock scew
25. Fastening bolt
26. Locking screw for workpiece support
27. Knurled screw for cutting depth limiter
28. Stop for cutting depth limiter
29. Adjusting screw
30. Adjusting screw
31. Flange bolt
32. Outer flange
33. Button
34. Transport handle
35. Laser
36. ON/OFF switch for laser
37. Release device
CAUTION ! - LASER RADIATION !
Do not look into the beam!
Laser class 2;
Wave length: 650 nm;
Maximum output: ≤1 mW