After Sales Support
TEL: 07 3188 2025
WEB:
helpdesk
@
duons
.
com
.
au
9
Belt & Disc Sander
After Sales Support
TEL: 07 3188 2025
WEB:
helpdesk
@
duons
.
com
.
au
Push the sanding belt along both of the transport rollers, starting from the back of the
•
machine.
Push the clamping handle completely to the left. Now the sanding belt should be
•
completely tight.
Turn the transport roller exactly in a right angle to the direction of the sanding belts with
•
the use of the winged nut at the right roller. The direction of running of the belt is adjusted
correctly if the sides of the sanding belt are running parallel to the bearing plate.
the sanding disc
Paper or “velcro” plates are used for the sanding disc. The standard diameter is 150 mm. The
plates are self adhesive.
Vertical placing of the sanding belt
For more flexibility of the sanding belt its bottom side can be used, because there is no bearing
plate. For an easy reach of this bottom side the sanding belt can be placed in vertical position.
Loosen the two nuts at the front of the sanding machine, around the left transport roller
•
shaft, with the use of an open-end spanner.
Push the sanding belt up in the position desired.
•
Fasten the two nuts again.
•
The workpiece can now rest on the worktop instead of on the sanding belt;
•
The work plate which is used for the sanding disc can now be pushed with the shaft into
•
the hole of the machine frame, at the left side of the sanding machine.
Fasten the bolt at the back of the machine.
•
The work plate can now be used as support for the sanding of the work piece against the
•
sanding belt.
ASSemBly AnD SPAre PArtS
Spare parts list
Position
Description
no.
126140
Guide roll
2
126141
Adjustment knob
9
126143
Drive roll + shaft
14
126142
Capacitor
17
126144
Motor pulley
29
126145
Sander disc
35 + 36
BGM6019 Ma 1112-13.indd 9
13-12-2011 08:44:46
