Taurus ALPATEC MG10, Руководство пользователя

Страница: 14 / 100

Note: Please do not touch hot water as the tem-
perature may be too high
press this button to power on the
machine
INSTALLATION
- Make sure you have removed all packing
material. In order to prevent possible risk of
accidents, do not leave items such as plastic
bags, polystyrene or cables within the reach of
children.
-During transportation, the tilt angle of the appli-
ance must not exceed 45 °. Do not locate the
appliance upside down as this may damage the
compressor.
- Place the appliance on a flat, stable surface
and away from any heat source.
- The appliance requires proper ventilation in
order to operate correctly. Leave a free space
of 15 cm around the appliance.
- Do not obstruct the opening of the door of the
appliance.
- The socket should be easily accessible in order
to be able to quickly disconnect the appliance in
case of an emergency.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products’ packaging has
been removed.
-Before using the product for the first time, clean
the parts that will come into contact with food in
the manner described in the cleaning section.
-It is recommended that you wait for a minimum
of 2 hours after having installed the appliance
before you use it for the first time, leaving the
front cover open.
- Prepare the appliance according to the function
you wish to use:
STEP 1:ADD WATER
- If bottled water is used, remove the paper seal
and plastic, then tip bottle onto the cleaver seat,
water will release into the machine automatical-
ly if pipe is used,
-Note: Inlet water pressure should be within
0.1-0.4Mpa
USE:
- Unroll the cable completely before plugging it
in.
- Fill the appliance with water (Fig 1) Do not
place any liquid other than drinking water in the
tank.
- Connect the appliance to the mains..
-Step 2: Connect to power and press to
start the machine.
-Step 3: Press the right buttons to start the func-
tion you want.
- Note: After the water is filled, press
first then till water comes out from
the water faucet lastly press for making
hot water so as to avoid the heater going into
automatic protection.
- Note: For the first three cycles, the ice may be
small and irregular in size.
- If no water is pumped up to the water tray over
two cycles, then please open the drain cap and
let several drops water runs out.
GETTING HOT /COLD WATER / ICE
- 4.1 Hot water: Press button then
to get hot water.