UP050-EN Nozzle FN-1024 - Instruction and Maintenance Manual_rev2.docx
- 3 -
2-2. Installation
1. The nozzle must be set up with TATSUNO single swivel (FJ-1006) or double swivel (FJ-1045).
Inlet thread connection of swivels for hose-sided coupling: G 3/4 "female or G 1” male (with single
swivel FJ-1006 only)
2. Shut off power to the dispenser before starting the nozzle & swivel installation or replacement. Relieve
system pressure before servicing or replacing.
3. Carefully drain fuel from hose & nozzle & swivel into approved container in the case of replacing nozzles.
4. In case of nozzle & swivel replacement, use new TATSUNO Gasket to connect with the hose.
The tightening torque of the screw: 70N.m.
5. Flow test nozzles & swivels before putting nozzles & swivels in service.
See testing instructions. (Reference page 4)
WARNING
1. Please read safety instructions "HINTS AND TIPS FOR SAFE USE" completely before installing and
replacing nozzles.
2. Discharge your static electricity before installing.
Static electricity may ignite gasoline vapours.
3. Not to mix rubbishes into the nozzle when installing and replacing
nozzles. This could result in foreign material in the nozzle’s main valve
and cause the nozzle to not shut off.
Single Swivel
Double Swivel
Gasket
Gasket
2. Instruction
