PREPARING THE VEHICLE FOR THE DRIVE
10.
Check level of water
in Windshield washer reservoir.
Top up with clean water if required.
Use good quality cleaning solvent available in the
market in the ratio as specified by its manufacturer.
11. Check oil level in power steering hydraulic tank, where
applicable.
12. Check and correct tyre inflation pressure ( with cold
tyres ).
1. Rear windshield washer reservoir
2. Clutch Fluid Container
Windshield washer reservoir
Power Steering Fluid Dip Stick
H A N D L I N G
50
1
2
51
D R I V I N G I N S T R U C T I O N
BEFORE DRIVING
Check
l
Fuel level
l
Coolant level
l
Engine oil level
l
Tyre pressure
l
Brake and clutch fluid level
l
Doors are firmly closed
Adjust
l
Driver seat
l
Rear view mirrors
Ensure
l
Gear shift lever is in neutral
position.
l
All switches and lamps are
working.
l
Brake fail indicator is ‘OFF’
Start the engine and observe that :
l
Low oil pressure indicator light
goes ‘OFF’
l
Battery charging indicator light
goes ‘OFF’
l
DO NOT CRANK ENGINE WHEN
GLOW PLUG INDICATOR IS ‘ON’
l
ENSURE THAT PARKING BRAKE IS
RELEASED (INDICATOR LAMP ‘OFF’)
l
VEHICLE IS NOW READY FOR A
DRIVE.
l
DO NOT ALLOW VEHICLE TO ROLL
BACK ON GRADIENTS.
Stopping the engine :
a.
Park the vehicle in safe place. Apply
parking brake.
b.
If NA engine, stop the engine by
turning ignition switch to ‘OFF’
position.
c.
If turbocharges engine run the
engine idle for atleast 30 seconds
and then switch off this will allow
the engine oil to lubricate the turbo
charger, till its speed is fully reduced
and also allow the unit to cool
down.
A b o v e p r e c a u t i o n w i l l e n s u r e
satisfactory life and performance from
the turbo charger.
DRIVING AND GEAR SHIFTING
During running - in period :
i.e. first 2,000 km of operation :
Do not exceed the following vehicle
speeds :
Victa NA Victa TC
Gear
Min
Max
Min
Max
1st -
25
-
30
2nd 15
45
15
55
3rd
25
75
25
90
4th
30
100
35
120
5th
40
Max
45
Max
l
Avoid rapid acceleration and
prolonged high speed running of
the engine.
l
Avoid sudden braking.
l
Retighten wheel nuts to 12-15 mkg.
torque after first 100 km of running
of a new vehicle and after every
wheel change.
Ofrecido por www.electromanuales.com
