39
I25
I24
I23
I22
I21
I20
I19
I18
tr
sv
sl
ro
pt
pl
no
nl
it
hu
fr
fi
es
en
de
da
cz
Maintenance of batteries (only wet batteries)
Please follow the instructions of use for your battery charger!
Opening battery compartment for maintenance
Closing battery compartment
After end of maintenance
Preparing to drive
Attaching tools
Check:
• that the brushes are not below the red marking and that the bristle length is
no less than 1 cm.
• the pad for wear before using.
Variant:(Option 1255) Automatic brush lowering
Tank position for charging.
• Connect the battery disconnection socket to the external battery charging
unit (pay attention to the voltage from the mains supply socket).
Caution:
Follow the instructions for use for your external battery charger!
• Turn on the battery charger.
Caution:
When maintenance of batteries takes place, they must be
disconnected from the machine!
• Check that the machine has been switched off with the keyswitch.
• Disconnect the battery from the machine using the battery disconnection
socket.
• Lower the squeegee.
• Check that the tanks are empty.
• Unlock the battery compartment, by pushing a
screw driver or a similar tool into the allowed
opening.
• Lift the tank until it locates into its self support
position.
Tank position before it is altered for battery
maintenance.
• Lock the tank lid.
• Stand behind the machine.
• Carefully open the battery compartment until
the drive handle is lying on the floor.
Tank position for battery maintenance.
• Stand behind the machine and lift the tank until
it rests on the tank self support.
• Hold the tank and press the tank support
inwards.
Now lower the tank until it locates into place.
• Connect the battery to the machine with the battery disconnection socket.
• Raise the squeegee.
• Switch on the keyswitch.
The indicators light up briefly.
The battery indicator displays that the machine is
ready for operation
(on malfunction see page 44).
• Hold the handle and adjust to a height which is
comfortable to work with.
By lightly pressing the speed control in the
direction of drive, the machine is set in motion.
Letting the speed control go stops the machine.
• Switch the machine off using the keyswitch and remove the key.
Working with worn out, damaged and or wrong tools, could result
in possible damage to floors or their protective layers.
• Position the tool below the brush unit.
• Switch on the keyswitch.
The indicators light up briefly.
• Press the brush unit button.
While being lowered, the brush drive begins to
pulse slowly. This centres and locks the tool into
place.
The display lights up
.
