15
6. Start engine following instructions
How to
Start Your Pressure Washer
.
7. Apply detergent to a dry surface, starting
at lower portion of area to be washed
and work upward, using long, even,
overlapping strokes.
8. Allow detergent to “soak in” for 3-5 minutes
before washing and rinsing. Reapply
as needed to prevent surface from
drying. Do Not allow detergent to dry on
(prevents streaking).
iMPORTANT
: You must flush the detergent
siphoning system after each use by placing the
filter into a bucket of clean water, then run the
pressure washer in low pressure for 1-2 minutes.
Pressure Washer Rinsing
1. Remove black spray tip from nozzle
extension.
2. Select and install desired high pressure
spray tip following instructions
How to Use
Spray Tips
.
3. Keep spray gun a safe distance from area
you plan to spray.
4. Apply a high pressure spray to a small area
and then check surface for damage. If no
damage is found, you can assume it is okay
to continue rinsing.
5. Start at top of area to be rinsed, working
down with same overlapping strokes as you
used for cleaning.
Cleaning detergent Siphoning Tube
If you used the detergent siphoning tube, you
must flush it with clean water before stopping
the engine.
1. Place detergent siphoning tube/filter in a
bucket full of clean water.
2. Remove high pressure spray tip from
nozzle extension.
3. Select and install black detergent spray tip
following instructions
How to Use Spray Tips
.
4. Flush for 1-2 minutes.
5. Shut off engine following instructions
How
to Stop Pressure Washer
and turn off
water supply.
6. ALWAYS point spray gun in a safe direction
and squeeze spray gun trigger to release
retained high water pressure.
WARNiNG
: Kickback from spray gun can
cause you to fall.
Operate pressure washer from a
•
stable surface.
Be extremely careful if you must use the
•
pressure washer from a ladder, scaffolding, or
any other similar location.
Firmly grasp spray gun with both hands when
•
using high pressure spray to avoid injury
when spray gun kicks back.
NOTICE
: You must attach all hoses before you
start the engine.
Starting the engine without all the hoses
•
connected and without the water turned ON
will damage the pump.
Damage to equipment resulting from failure to
•
follow this instruction will void warranty.
WARNiNG
: The high pressure stream of
water that this equipment produces
can cut through skin and its underlying
tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure,
even when engine is stopped and water is
disconnected, which can cause injury.
Keep high pressure hose connected to pump
•
and spray gun while system is pressurized.
ALWAYS point spray gun in safe direction,
•
press red button and squeeze spray gun
trigger to release high pressure, every time
you stop engine.
