80
TASCAM DR-60D
8 – Mixer
5. Press the DATA dial to return to the previous screen where you
can select the next setting that you want to adjust.
NOTE
•
The mixer can be used when the unit is stopped, paused, playing
back, in recording standby and recording.
•
Even when the
MIXER
screen is open, you can use the
play
(
7
)
button to start playback and the
stop
(
8
) [
HOME
] button to
pause playback.
•
If the
MS MODE
item is changed, it will also be changed on the
REC MODE
screen.
•
The
MS MODE
cannot be changed when recording.
Using the MS decoder
When using MS mics to record, you have two decoding options.
You can decode the input sound as you record or you can record
as is and decode during playback. The following explanation uses
channels 1 and 2. If the mid-side mics are connected to channels 3
and 4, however, use the same procedures but substitute channels 3
for 1 and 4 for 2.
Decoding the input sound as you record
1. Connect MS mics to the 1/L connector and 2/R connector.
Connect the mid mic to the 1/L connector and the side mic to
the 2/R connector.
Decoding cannot be conducted properly if the mid and side
mics are connected in reverse.
2. On the
REC MODE
screen, set the
REC MODE
to
STEREO
,
DUAL
ST
or
4CH
, and set the
SOURCE
to
CH1/2
.
NOTE
If
4CH
is selected on the
REC MODE
screen, the
SOURCE
item will
not be shown and does not need to be set.
3. Set
MS MODE
to
REC
.
If
4CH
Is selected on the
REC MODE
screen, set
MS MODE 1/2
to
REC
.
