TASCAM CC-222MKIII
Note the following when loading tapes:
1 Use your finger or a pencil to turn the cassette's
hub and take up any slack tape.
NOTE
Avoid touching the tape. Fingerprints attract dust
and dirt.
2 Press the
EJECT
key to open the cassette com-
partment door.
3 Load the cassette tape with its open edge facing
down.
4 Gently close the compartment door.
NOTE
The cassette holder cannot be opened during
recording or playback.
If the power has been switched off during play or
recording, ejecting the cassette may be impossible.
In such a case, switch the power on and press the
EJECT key again.
7- Cassette operations
Continuous tape/CD playback
1 Load the tape as described above into the unit.
Load the disc recorded side downwards using the
OPEN/CLOSE
key.
2 Press the
CD-TAPE CONT PLAY
key.
3 Press either of the
PLAY
keys of the tape deck, or
the
PLAY
key of the CD deck.
Playback will start on the appropriate unit.
When playback reaches the end of the disc, or
the end of the tape as determined by the
REV
MODE
setting, playback starts on the other unit.
NOTE
Media (tape or disc) can be changed in the unit that
is not playing.
4 To stop playback and cancel the mode, press the
CD-TAPE CONT PLAY
key again.
NOTE
The cassette deck and CD deck can be used to
play back through different outputs, or the
LINE
OUTPUTS 2
jacks can be used for both disc and
tape playback. However, note that if both are play-
ing, the cassette takes priority (the disc will not
be heard through these outputs). Disc playback is
always through the
LINE OUTPUTS 1
jacks.
Playback operations
WARNING
If you are monitoring using headphones, first adjust
the level control to low on the unit, then connect to
the POHNES jack before playing back. This will pre-
vent any possible damage to your hearing.
1 Set the
REV MODE
switch to the required tape
mode.
Ä
Single-sided playback
Ë
One side, then the other side, then stop
ä
One side, then the other side, then the first side
again, etc.
Also, check the
MONITOR
switch is set to
TAPE
.
2 Load a pre-recorded cassette with its open edge
facing down and side A facing toward you.
3 Set the
DOLBY NR
system on or off.
4 Press either
PLAY
key to start playback.
5 Adjust the volume with the amplifier’s volume
control.
6 To stop playback, press the
STOP
key.
