Target LaserTrack LT400, Руководство пользователя

Страница: 5 / 14

CABLE CONNECTION:
LT400 Connect to:
1. Red Switched 12 V from the vehicle (+15).
This is the cable with 12 V as soon as
the vehicle is started. Mount a fuse for
this connection. A switch can be added
to this connection if required.
2. Black Earth. Connect this cable to a good earth
source. Preferably a section of the chassis
of the vehicle.
3. Yellow Connect with the red cable of the Piezo
signal device. Connect the black cable of
the signal device to earth.
4. White Connect with the red cable of the LED.
Connect the black cable of the LED to
earth.
5. Green Do not use. Insulate the cable using
insulating tape.
6. Blue Do not use. Insulate the cable using
insulating tape.
TRANSPONDER ALIGNMENT
The correct alignment of the transponder is very important.
It should be aligned correctly
vertically and horizontally.
Vertical alignment: Upwards / Downwards. The transponder
can be adjusted upwards or downwards by turning the angle
iron included in the package. This is the vertical alignment.
Make sure the vehicle is level. Use the water leveller in-
cluded in the package to adjust the vertical position. Place
the water leveller just above the transponder and fasten
the transponder in the correct position.
Horizontal alignment: Left / Right. The transponder can be
turned around itself using the tee bolt. This is the horizon-
tal alignment. The transponder should be placed at a right
angle of the vehicle.
ENGLISH
7
90
°
90
°