Target LaserTrack LT400, Руководство пользователя

Страница: 10 / 14

PROGRAMMING THE
TARGET LASERTRACK
1. Park your vehicle at a few meters distance and in
line with the basic transponder. Make sure that the
LT400 is in stand-by mode.
2. Press the BUTTON-1 or BUTTON-2 button (depending
on the group it is connected to) on the control circuit
board for 2 seconds.
Result: The corresponding LED blinks. LED 10 shall blink
for 10 seconds and it will subsequently start flash-
ing when the code from the LT400 is received.
The code of the vehicle is saved in the memory.
OR
Result: The corresponding led blinks repeatedly for
30 seconds after which it returns to the usual
flashing pattern. This means that the code of
the vehicle has not been received. Check the
position of the vehicle and the basic trans-
ponder and repeat the procedure from step 2
onwards.
A maximum of 50 vehicles can be programmed into the
system in the above manner.
Program the second transponder in manner described
above if you have connected two LT420 transponders
to a single control circuit board.
Important: The car transponder concerned has to be
reset after programming the LT400 car transponder.
The LT400 switches off after a programming cycle to
prevent the gate or garage door to be opened imme-
diately.
DELETING VEHICLES FROM
THE BASIC SYSTEM MEMORY
All the codes saved in the memory of the connected
transponder shall be deleted if you press
BUTTON-1
or BUTTON-2 for more than 5 seconds. The LED shall
blink 5 times to confirm it.
The vehicles that should have access should be pro-
grammed into the memory again.
ENGLISH
12