5
INSTALLING THE PROBES
•
Ensure you have already configured your Probe
Sensors and Receiver (see page 4).
•
The tune selected for the
A
button corresponds
with the car passing Probe A then Probe B.
•
The tune selected for the
B
button corresponds
with the car passing Probe B then Probe A.
•
The wire and Probe Sensors should be buried at
least 70mm below the surface to prevent damage
from garden equipment.
•
If anything heavier than a ride-on lawn mower will
drive over the Probe Sensors or wire, it is best to
bury them up to 30cm deep and place in a conduit
to prevent damage.
1. Lay the Probe Sensors on top of the ground
perpendicular to the driveway with the Probe Sensors
1.2m apart. As a general rule, when a vehicle enters
the driveway they should pass Probe “A” first then
Probe “B”.
2. Drive a car by the Probe Sensors to test the position.
You should hear a chime from the Receiver.
3.
After you have tested and confirmed the location of
the Probe Sensors, bury the Probe Sensors.
4.
After burying the Probe Sensors, fix the Transmitter
Box to a tree or post nearby, approximately 1.2-1.5m
above the ground, and bury the wire.
INST
ALLA
TION.
Содержание DUAL-4000-ANZ
Страница 1: ...DIRECTIONAL PROBE ALERT KIT INSTRUCTION MANUAL DUAL 4000 ANZ DUAL 4K PLUS ANZ...
Страница 2: ...2...