Targa lupilu LBP 864 A1, Инструкция по эксплуатации и правила безопасности

Страница: 15 / 38

Lupilu LBP 864 A1
English - 13
7. Getting started
7.1 Switching on the baby monitor / Selecting the channel
You can select from 2 RF channels (A and B) for transmission. If you get interference on one channel,
use the other one.
Proceed as follows to switch on the baby monitor and select a channel:
Push the channel selector switch (11) on the baby transmitter unit (B) to the left to switch the device on
and transmit on Channel A. Or push it to the right if you wish to use Channel B.
Push the channel selector switch (4) on the parent receiver unit (A) to the left to switch the device on and
receive on Channel A. Or push it to the right if you wish to use Channel B.
Both devices (the parent receiver unit (A) and the baby transmitter unit (B)) must be set to
the same channel.
The indicator lights (2, 10) on both devices then light up. The indicator light signals have the following
meanings:
Indicator light Baby transmitter unit (B) Parent receiver unit (A)
On, green. Device switched on. Device switched on (receiving
carrier signal from channel A or B).
Flashing, green. – Sound signals are being received
from the baby transmitter unit (B).
On, red. Rechargeable or conventional
batteries empty Rechargeable or conventional
batteries empty
Flashing, red (4x per
second). – Weak signal (out of range).
7.2 Switching the baby monitor off
Push the channel selector switch (4, 11) on the parent receiver unit (A) and the baby transmitter unit (B)
into the middle position to switch the devices off. The indicator lights (2, 10) go out.
8. Use
1. Place or hang the baby transmitter unit (B) in the child’s room.
2. Switch both devices on by selecting a channel using the channel selector switch (4, 11).
3. Set the receiver volume you want using the volume controller (3). Do not get too close to the baby
transmitter unit (B) or you will hear a loud feedback noise.