Targa lupilu LBP 864 A1, Инструкция по эксплуатации и правила безопасности

Страница: 13 / 38

Lupilu LBP 864 A1
English - 11
1. To do this, twist the handle (5, 13) upwards.
2. Undo the screw on the cover of the battery compartment (6, 14) (see arrow). Use a Phillips
screwdriver.
3. Open the cover of the battery compartment (6, 14) and place three rechargeable AAA batteries
(NiMH) or three conventional AAA batteries in the battery compartment. Take care to observe the
correct polarity (note + and -).
4. Then close the cover of the battery compartment (6, 14) and tighten the screw again.
DANGER!
The cover of the battery compartment must be secured using the screw provided to ensure
that small children cannot remove the batteries. Swallowing the batteries could be fatal!
5. Switch the parent receiver unit (A) and the baby transmitter unit (B) on using the channel selector
switch (4, 11). The parent receiver unit (A) and the baby transmitter unit (B) have an indicator light
(2, 10) on the front. If these are lit, the batteries are inserted correctly. Otherwise, repeat the steps
above and check the polarity. See also the table for a description of the indicator light in the
“Switching on the baby monitor / Selecting the channel” section on page 13.
6.2 Connecting the power adapter
On the back of the parent receiver unit (A) and the baby transmitter unit (B), there is a power adapter
input (7, 15). Two power adapters are provided so you can operate both the parent receiver unit (A)
and the baby transmitter unit (B) from the mains power at the same time, if needed.