Targa DataBox IV 320, Руководство пользователя

Страница: 9 / 14

Targa DataBox IV 320 English
9
Connecting via the eSATA Cable
To use the SATA standard your computer must have available an external SATA
connector (eSATA). This should be properly installed on your operating system.
Depending on the manufacturer of the eSATA connector, you must also have the
corresponding driver installed on your computer. If you are not sure whether the
connector is correctly installed, check in the documentation of your computer or in the
third-party expansion card.
The Targa DataBox IV 320 is designed for the eSATA standard and therefore offers
also "Hot Swap" technology. This means that you can connect and disconnect the
Targa DataBox IV 320 from your computer without having to shut down the operating
system.
On first use – depending on the hardware used – an automatic message may appear
or an acoustic signal may be heard.
1. Insert any connector of the eSATA cable [C] into a free eSATA port on your
computer.
2. Next connect the other connector of the eSATA cable to the eSATA port [4] of
your Targa DataBox IV 320.
3. Power on the Targa DataBox IV 320 using the On/Off switch [2]. The
operating system will automatically detect that a new device has been
connected and will install the corresponding driver.
Just as with a USB connection, the eSATA connection of the Targa DataBox IV 320 is
immediately ready for use and is added to "My Computer" of your operating system. In
addition, the Targa DataBox IV 320 automatically obtains a specific drive letter. The
drive letter assigned depends on the number of disk drives you already have connected
to your computer.
Figure: Drive in "My Computer"