Tarasola Cubic, Руководство по эксплуатации и обслуживанию

Страница: 10 / 14

10
covered by the warranty.
Waves - may form close to the sewing or welding of the fabric as well as on
the side of the edge, due to double thickness of the fabric.
Fraying and abrasion - if the canopy is exposed to constant high winds, it
may show signs of wear, tear, and abrasion. This may occur after many
years of misuse.
4 CANOPY USER MANUAL AND GENERAL SAFETY REGULATIONS
Proper functioning and avoidance of breakdowns resulting from
improper use shall be ensured by following the rules below. The
entirety of the support is burdened with a load which may cause
oscillatory motion. This motion is not an indicator of structural
weakness but shall be considered normal for a complex structure.
Therefore, deviations and motions of the structure shall be allowed.
Repeated opening and closing of the canopy may overheat the
electric drive, thus activating the thermal switch which shall
disconnect the power supply. The motor shall remain off until the
temperature is adjusted.
It is forbidden to use the canopy in conditions and for purposes
different to those provided for by the manufacturer, which shall be
to
act as sun, and rain protection.
It is forbidden for third parties to place any items, install additional
fixings, hooks, hangers on the canopy structure without
manufacturer’s consent. This increases the risk of product failure
and shall result in the product warranty being voided.
Be careful when opening and closing the canopy. Due to the risk of
damaging one’s hands, it is forbidden to touch the structure when
it is in work mode.
The structure is not of a self-cleaning nature. Cleaning shall be
performed only after turning off the electric power supply of the
canopy. Cotton cloth and water with light detergent are
recommended to clean the structure.