Tar River SSC-100, Руководство оператора

Страница: 16 / 34

16
Fertilizer Spreader SSC - SSS - SP Series
Operating Instructions
Attaching to the tractor
1. Back the tractor to the spreader carefully. Turn off the tractor and set the park brake. Be sure
there is nothing between the tractor and the spreader including people or animals. There is a
possibility of serious injury or death.
2. Slide the tractor lower arms over the welded pins on the spreader. Secure with lynch pins.
Next, connect the top link to the spreader and secure with the top hitch pin.
3. The spreader disc must be horizontal to spread material uniformly. Adjust the tilt by twisting
the Top Link Arm in or out.
4.
Adjust the height of the spreader to approximately 28” from the bottom of the spreader disc to
ground level, (Fig. 1).
5. Install the PTO on the spreader
and then the tractor. Be sure to se-
cure both ends with proper pins or
bolts. Serious injury or death can
occur from improperly secured
PTO shaft. It may be necessary to
shorten the PTO. See instructions
on
“ How to Shorten PTO Shaft ”.
Shortening a PTO Driveline
1. With the implement attached to the tractor ’ s three point hitch, and the PTO driveline not installed, separate
the PTO driveline. Attach the implement end to the imple-
ment and the other end to the tractor PTO input shaft.
2. Raise the implement by using the tractor ’ s hydraulic 3 - point
hitch to it ’ s maximum lift height.
3. Hold the half shafts next to each other and mark them so each
end is approximately ½
” from hitting the end of the telescopic
profiles.
4.
Shorten the inner and out guard tubes equally.
5. Shorten the inner and outer profiles by the same length as the
Fig. 1
Do not shorten too much, the proper overlap is a minimum of 1/3 the length of each
profile.