Web Front-end
MECip
SECURE
- 38 -
6.5
IP Firmware Update
Under the Update tab the MECip-Sec firmware can be updated via IP i.e. the Ethernet
network. The complete remote update process is described in following steps. During this
process, MECip-Sec enters its boot mode. Then LEDs 1, 2, 3 and 7 light as described in
Table 5: LED Status Display for Firmware Update
If boot mode is already active only the web front-end instructions from step 3 to step 5
must be followed (refresh, request update).
To exit boot mode, it is necessary to enter the Update tab of the web front-end. Then, either
the firmware update has to be completed (like shown by steps 1 to 5) or the firmware update
process has to be stopped by a click
on the “Abort”
button (see step 5,
). After that,
MECip-Sec restarts and continues with normal operation.
Step 1:
Open the Update tab of the web front-end.
Figure 25: Update Tab
Step 2:
Activate Programming Mode (KNX tab or Programming Button).
Figure 26: Update Tab and activated Programming Mode
