Tannoy V12HP Скачать руководство пользователя

Страница: 5 / 28

All Power V™ loudspeakers are equipped with highly efficient, flexible and reliable Class D power amplification incorporating
switching power supplies. Optimally matched power supplies and power amplifier sections minimises noise and enhances
stability. Little is required in the way of heat sinking so the only surface area needed for cooling is the small control panel on
the rear of the cabinet; therefore, even when driven at very high power levels no fans are required, so the system runs quietly
and is not prone to internal dust contamination.

When used as a stand-alone speaker there is, on the rear panel of the full range Power V™ models, a mode switch for ‘Full
Range’.Alternatively the ‘High Pass’ position provides increased headroom for when the unit is used within close proximity to
a boundary and, in a simple setup, allows crossover to a subwoofer without the need for an external crossover.

LED’s on the rear panel indicate, signal pressence, signal activity, and power. Two low pass settings on the subwoofer amplifiers
fully optimise integration with the full range units.

Recessed carrying handles aid manoeuvrability and multiple flying points are incorporated to provide a quick and secure flying
system. Tannoy’s proprietary Secur-ET™ modular mounting hardware provides the Power V™ range with multiple hanging
options such as wall mount brackets, yoke fittings, ceiling saddles, pole clamps, pole mounts and eyebolts.

3.0: UNPACKING AND VISUAL CHECKS

Every Tannoy PowerV™ product is carefully tested and inspected before being packaged and leaving the factory. After

unpacking your loudspeaker, please inspect for any exterior physical damage, and save the carton and any relevant packaging

materials in case the loudspeaker again requires packing and shipping. In the event that damage has been sustained in transit

notify your dealer immediately.

3.1: PRELIMINARY RECOMMENDATION

A word of warning on high sound levels - these speakers are capable of generating high output levels over sustained periods

of time and such levels, over 95dBspl for 8 hours per day, can eventually cause permanent hearing loss. Since Tannoy

loudspeakers have a natural-sounding flat frequency response and low distortion, it's possible not to be aware just how high

the sound level is high while working with them.

For continuous exposure we recommend the occasional use of a sound level meter. This should be capable of integrating the

sound level over a period of exposure according to noise control standards and used just to check that noise levels are always

within safety limits.

4.0: INTERFACE PANEL

XLR FEMALE AUDIO INPUT - This is a lockable XLR line input
socket for connection to the audio source. Fully balanced.
Pin 2 Hot (+), Pin 3 Cold (+), & Pin 1 Ground.

XLR MALE AUDIO LINK - This is a lockable XLR line output socket
to link additional speakers. Fully Balanced.
Pin 2 Hot (+), Pin 3 Cold (+), & Pin 1 Ground.

ROCKER POWER SWITCH - Turns AC power on to the unit (100V
- 240V)

FUSE HOLDER - Replace only with 10A 230V anti-surge fuse.

AC MAINS CONNECOR - Neutrik Powercon mains connector
(supplied)

SIGNAL PRESENT LED - LED indicates when signal is being been
received by the speaker.

LIMIT LED - LED indicates when the integral limiter is functioning
to protect the speaker.

POWER LED - LED indicates when power has been applied to the
speaker.

MODE SWITCH - Switch allows the speaker to be toggled between
two modes;

• The subwoofers can either have an 80Hz or 110Hz low-pass

filter (LPF) filter activated.

• The full range speakers can either be run full range or have

a fixed high-pass filter (HPF) activated.

LEVEL CONTROL - Control allows adjustment of the speaker volume.