18
3
Near-infrared
transmitting
head
The near-infrared transmitting signal makes the Cleaner run outside the virtual
wall scope of 50-100cm without any impact to it.
4
Power LED
The Power LED will flicker once every 8s until the low battery after you slide
to
Low,
Middle and
High, and the Cleaner works normally.
:
1
．
Open the battery bottom before using, check the right positive and negative electrode and place 2x”D” batteries into
the box correctly. Pay attention to the electrode or the virtual wall will not work, resulting the damage and accident.
2
．
The battery consumption duration is related to the selected transmitting distance and working duration, please select
proper transmitting distance and low transmitting power to save the battery, so don’t forget to turn off the toggle
switch while the virtual wall is unused.
3
．
There will be some difference in the direction, transmitting infrared signal of the virtual wall and receiving distance
of the Cleaner due to environmental impact and movement of the Cleaner during the actual using. The difference
above may vary based on the actual environment and different battery power of the Cleaner and virtual wall.
Installation method of Virtual Wall
1.
The virtual wall is placed at the entrance to the stair or room generally.
2.
You can place the virtual wall at proper position to stop the Cleaner passing through some places.
3.
Remove obstacles from the area you want to block in front of the virtual wall as much as possible for fear of
poor effect.
1.
The virtual wall should be placed at the same level of the ground where the Cleaner is running.
2.
You should check whether the Cleaner can pass the virtual wall while using it first.
3.
The distance between the virtual wall and recharger should be more than 2.5m, or there will be interference.
4.
The Docking Station should not be installed within the signal scope of the virtual wall.
