element User Manual v1.17 rev2
14
16.
Care of your panel
Your panel should not be cleaned with harsh abrasives or chemical cleaning products. If
they become dirty wipe them with a soft damp cloth.
Sharp objects, watch straps and jewellery will scratch the soft texture of the paint
surface, so be careful not to bring such items in contact with the paint.
16.1 Cleaning the balls
From time to time you may need to clean the balls
and the trackerball unit that holds them. To do this
you need to remove the ring and then remove the
ball. Clean the ball with a soft damp cloth. To clean
inside the trackerball unit use a damp cotton bud,
paying close attention to the three white balls the ball
sits on, and the lenses which houses the optical
sensor.
The ring on the trackerball is held in place by magnets in the ring. When replacing the
ring make sure it locates correctly down on the trackerball. If it’s in place correctly then
there will be about a 1mm gap between the bottom of the ring and the panel surface.
17.
Firmware updates
The firmware in your Wave panel was the most up to date version when your panel was
manufactured. It is possible however that a newer version may be available from our
website www.tangentwave.co.uk. Check there under the support tab to see if a newer
version is available. Also be sure to read the instructions and release notes with the
version.
To find out what version of firmware your panel is running you will need to put the panel
into test mode. See the
Test mode
section of this manual.