5
General Instructions
Faucet Installation:
1. Drill
(2)
two holes, approximately
1-1/4” diameter in countertop with 8”
centers, where you are installing
no.
2
.
2. Apply Teflon tape or pipe joint
compound to water supply lines.
3.Connect no.
2
to water supply lines
by screwing no.
3
(with eccentric
centers)
onto nipple
(supplied by
others)
and tightening no.
3
against
countertop.
(Nut under countertop
to be supplied by others)
. Trim
supply lines if necessary.
water supply line
countertop
nut
(supplied by others)
8”[20 cm]
3
2
Nozzle Installation:
Note: Nozzles should be installed
first. See diagram below:
If installing to an existing rigid pre-
rinse unit or base faucet
1. Shut off water supply and drain
lines. Remove no.
21
from no.
2
.
Apply Teflon tape or pipe joint
compound to threaded ends of
no.
10
.
2. Place no.
10
into no.
2
and tighten
firmly by hand.
To Install Swing Nozzle:
1. Insert no.
14
into no.
11
and rotate
to desired position at sink.
Note: See Repair Kit
011643-45
for
replacement of no.
16
and no.
17
.
2. Tighten no.
20
firmly with a wrench.
14
10
20
11
Enlarged View
16
17
18
21
2
