T&R KV5-100 mk3, Руководство по эксплуатации и техническому обслуживанию

Страница: 12 / 21

11
2. OPERATION
2.1 Safety
The outputs from all units in the range are very dangerous, and if used incorrectly could be
fatal. The unit must only be installed, operated, and maintained by suitably qualified and
trained personnel.
It is essential to follow accepted safety procedures and local health and safety regulations and
guidelines when installing and operating high voltage equipment. A risk assessment should
be undertaken on both the installation and the working procedures to ensure the safety of test
personnel and all other personnel.
2.1.1 Installation
The unit is designed to be installed and used in an indoor environment.
2.1.1.2 Test Area
The unit must be installed in a suitable high voltage test area completely enclosed by walls or
some type of physical barrier. Appropriate controls and safety measures must be applied to
this area including interlocks connected to the supply or HV unit interlock to ensure that the
unit cannot be switched on unless the area is secure. Refer to BS EN50191:2001 and IEEE
Std 510-1983 for further details of suitable test enclosures. The test area must also be
identified with suitable signs.
2.1.1.3 Mains supply
The unit must be connected to a suitable supply via an approved and suitably rated mains
connector with earth connection.
2.1.1.3.1 Supply Voltage Selection
Disconnect the KV5-100 mk3 from the Mains Supply.
The supply voltage selector is located in the input socket module. The method of
selection is as follows:
a. Remove fuse drawer .
b. Remove and rotate fuse carrier until desired supply voltage is seen through
the fuse drawer window.
c. The KV5-100 mk3 is suitable for 2 different supply voltages as follows:
240V or 115V.
d. Replace fuse drawer once the desired voltage has been selected.
IMPORTANT! Under no circumstances should the supply voltage selector be altered when the
equipment is energised.
ALWAYS ENSURE THAT THE SUPPLY VOLTAGE SELECTOR IS IN THE
CORRECT VOLTAGE POSITION BEFORE ENERGISING THE EQUIPMENT