T&D MCR-4TC, Руководство пользователя

Страница: 19 / 64

17
Using MCR-4TC
Installing the Battery
Remove the battery cover from the back of the device, and insert
the supplied two AA alkaline batteries as shown in the figure below.
After the batteries are inserted, the [Please set the clock] message
will appear on the LCD.
* For information on how to set the clock, see p.41.
IMPORTANT
- Make sure to use new batteries of the same kind.
- Make sure not to m / -.
- Do not insert or change batteries with wet hands.
- Be sure to completely close the cover.
- The MCR-4TC cannot recharge batteries.
Usable Power Sources
- AA Alkaline Batteries
- AA Ni-MH Batteries
- AC Adapter (USB type)
- USB Bus Power
Changing the Batteries
If the battery runs down before it is replaced, MCR-4TC will
automatically stop recording to protect data. Check the battery mark
(see the previous page) and change batteries as necessary.
IMPORTANT
- To protect data, please stop recording first before changing batteries. Not doing so
may result in loss of data being recorded.
- When you wish to replace batteries while recording is in progress, make sure to
connect the USB cable to your PC for USB bus power.
- If the MCR-4TC runs out of power while processing data on a SD memory card, the
data on the card may be corrupted.