T&C TC36ST, Инструкция по установке и эксплуатации

Страница: 20 / 40

20 TC36.CSTE 082406-40
B
14 1/2"
A
ROOF SUPPORT
BRACKET
(TCVT.93915)
VENT PIPE
ROOF TERMINATION VENTING
Ceiling and Roof opening:
1) Determine the exact position of the fi replace so that the
vent pipe is centered (if possible) between two building
framing members. Lay out the vent system path, minimiz-
ing the number of elbows and length of vent. Consult your
local building codes prior to proceeding.
2) Cut and frame a 14-1/2" opening in the fl oor, ceiling and
roof where the vent system will pass. Size of the opening
through the roof may need to be increased as the pitch of
the roof increases. Avoid cutting rafters.
Ceiling fi restop:
Where a vent pipe passes through a fl oor or ceiling, a ceiling
fi restop must be used to retain insulation and maintain proper
clearances.
From below, push the ceiling fi restop through the opening
and secure in place. If the fi restop is used to penetrate a
fl oor, the outer shield may be trimmed in length. If the fi restop
penetrates into an attic, leave the shield full length to keep
insulation away from the vent pipe. Additionally, after the vent
pipe is in place, install a storm collar on top of the shield. This
will prevent loose insulation from falling into the area between
the vent pipe and the shield.
Vent pipe:
1) Install the fi rst section of vent pipe onto the collar on top
of the fi replace. Secure in place with screws and seal with ap-
proved "High Temp" self-adhesive aluminum tape provided.
2) Continue adding vent pipe lengths up and through the
fi restop(s) and through the roof. The vent pipe must extend
at least 24" above the roof.
Seal the vent pipe as per "Vent Pipe Sealant" section.
Roof support bracket:
Slip the roof support bracket down over the vent pipe. Rotate
the 90° brackets to accommodate roof pitch. Attach the brackets
to the roof joists with nails or building screws. Tighten the band
around the vent pipe and secure in place with screws.
Fig. # 42
Size of the opening will have to increase with
the pitch of the roof to ensure a 1 3/4 inch
air space clearance between vent pipe and
combustibles.
Roof Pitch A B
0/12 14 1/2" 7 1/4"
4/12 16 1/2" 8 3/4"
6/12 18" 10"
8/12 19
3/4" 11"
12/12 24" 13 3/4"
Fig. # 41