12 TC36.CSTE
082406-40
INITIAL SETTINGS
(time and temperature)
1)
Press and hold the A1 and A2 buttons at the same time
until the temperature symbol fl ashes. (Fig. #22)
2)
Use the up and down arrows to set preferred temperature
units. (°F or °C)
3) Press OK and the “hour” value will start to fl ash.
4) Use the up and down arrows to set the “hour” value.
5) Press OK and the “minute” value will fl ash.
6) Use the up and down arrows to set the “minute” value.
7) Press OK and the “day” value will fl ash.
8) Use the up and down arrows to set the “day” value.
9) Press ok to end the initial set up.
CHILDPROOF LOCK
An additional feature of this remote control is the childproof
lock. To activate this system press and hold the timer and
thermostat buttons for approx. 5 seconds until the “lock”
symbol appears on the remote display. (Fig. #24) The remote
control hand set buttons are now locked and the lock symbol
will reappear every time a button is pressed on the remote
control until the timer and thermostat buttons are pressed
and held again.
Note: The fi replace can still be operated normally using the
wall control even with the remote control buttons locked.
CONTROL SYSTEM - OPERATION
Each Town and Country Maestro Control system comes
equipped with a manual mode on the wall control and hand
held remote, and three programmable modes accessible with
the hand remote.
MANUAL MODE
(on remote and wall control)
Basic operation of the fi replace can be performed with the
wall control or remote hand set. (ON/OFF, as well as fl ame
modulation UP/ DOWN).
The center button on the remote control can be used to turn
the fi replace ON and OFF. With the fi replace off, press the
center button to turn it on. (The “MAN” and fl ame icons will be
displayed on the screen) A second push will turn it off. (The
“MAN” and fl ame icons will disappear from the screen)
When the fi replace is on, the up and down buttons located
above and below the center button are used to modulate the
fl ame height. (Fig. #25)
COUNTDOWN TIMER MODE
(Operates the fi replace for a preset length of time)
1)
Press the timer button and the time will fl ash on the lower
center of the display. (Fig. #26)
2)
When display is fl ashing, use the up and down arrows to set
the length of time you would like the fi replace to run. (The
range is 10 minutes minimum to 180 minutes maximum).
(Fig. #27)
3)
Press the OK button and the timer is set and the control
is in countdown timer mode.
4)
To exit the timer mode press the Program, Manual or
Thermostat buttons. Please note that the fi rst press of the
Manual button will turn the fi replace off.
PROGRAM MODE
(to preset up to two on and off periods per day)
The program mode has two settings for weekdays and two for
weekends. The hand held remote comes with the following
pre programmed settings:
Fig. # 24
Fig. # 25
HOLD
HOLD
FLAME
DOWN
FLAME
UP
ON/
OFF
Содержание TC36ST
Страница 38: ...38 TC36 CSTE 082406 40 NOTES...
Страница 39: ...082406 40 TC36 CSTE 39 NOTES...
