D14330.09 TANDBERG E20 ADMINISTRATOR GUIDE (TE2.1) February 2010
14
What’s in this Guide?
Introduction
Deploying E20
Using E20
The Settings
Advanced settings
Deploying E20
5.
Go to
Settings > Advanced > Advanced configuration > SIP >
Profile1
. Set
Default Transport
to
Auto
(which is the same as default),
Proxy1 Discovery
to
Manual
, You must also enter the IP address of
the Proxy (Proxy is your PBX/VCS or OCS) and you must enter the URI
of your E20. Set the
SIP Mode
back to
On
.
6.
If your SIP Server/PBX uses user authorization you need to supply
a user-id and password. This is done in
Settings > Advanced >
Advanced Configuration > SIP > Profile1 > Authentication 1
.
7.
You may want to use a TMS phonebook. If you have this and no entries
are displayed after configuring, you must make sure that your unit is
registered in TMS and a phonebook is assigned to your system.
Using the keypad to configure the E20
There are several ways of setting up the E20. This page explains how
to set up the unit using the keypad only, while how to set it up from a
remote PC is explained on the next page.
Press the
H
ome
key to produce the
Home
menu and navigate down to
Settings
. Press the
R
igHt
aRRow
key to produce the
Settings
menu and
navigate down to
Advanced
. Press the
R
igHt
aRRow
key.
Finally navigate down to
Advanced configuration
and press the
R
igHt
aRRow
key again. Navigation like this will hereinafter be shown as
Settings > Advanced > Advanced configuration.
1.
Navigate to
SystemUnit > Name
and press
oK
.
Select a name that is unique to avoid conflicts. We recommend
that you use your name or initials, eg. AliceWonderland. This name
will be seen as you by the others.
2.
In most cases DHCP will be used for assignment:
Go to the previous menu—the
Advanced
(use
L
eft
aRRow
key) and
navigate to
IP Settings > IP Assignment
, if the cursor is not there
already. Press
oK
and set to
DHCP
.
Alternatively, set it to
Static
and enter the
IP address
,
Subnet
Mask
and
Gateway IP address
.
3.
For remote administration the below settings are recommended.
This should also make the system visible in TMS.
In the
Settings > Advanced > Advanced configuration >
Provisioning > ExternalManager
set
Address
,
Protocol
,
Path,
Domain
and
Mode
, which will be
TMS
, if used.
4.
To be able to dial, you need to configure the SIP settings.
In the
Settings > Advanced > Advanced configuration >
NetworkServices > SIP
, set
SIP Mode
to
Off
before doing
anything else.
Your TANDBERG E20 comes with no default administrator
password set. This means that anyone with network access to the
E20 can easily log onto the device with ssh.
We strongly recommend that you set up an administrator password
by using the menu in
Settings > Advanced > Change
password
.
