11304801 Page 3
Installation Sheet
TANDBERG 8000
MXP
1) Dual Monitor Frame
Before mounting the monitor frame:
Remove the 4 nuts from the bolts protruding
1.
from the top of the base, using the wrench
found in the accessories box.
Remove 4 bolts by using an Allen key (unbrako
2.
key) found in the accessories box.
Carefully lift the dual monitor frame out of the
box:
Place the dual monitor frame on top of the
1.
base.
Use the 4 nuts and the 4 bolts (which was
2.
removed from the base) to fasten the dual
monitor frame in place.
Installation of TANDBERG 8000
MXP
To install the monitors we recommend that there are 3 people present.
NOTE!
Due to the weight of the system, the base should be placed in its permanent location at once.
Open the front screen, fastened by
1.
magnets.
Locate the holes on the monitor
2.
frame for mounting the monitors.
Carefully place the first monitor
3.
inside the dual monitor frame.
Enter bottom first.
Secure the monitor using the four
4.
M8x35 screws by using an Allen
key (unbrako key) found in the
accessories box.
Repeat step 2, 3 and 4 for the
5.
second monitor
Remove the protective plastic film
6.
from the plasma monitor front.
Close the front screen. Make sure
7.
the magnets engage.
2) Plasma Monitors
The front
screen