Tandberg Data SUPERLOADER DLT -, Быстрый старт, Страница: 8 / 14

e
f
g
If the autoloader will be the last device
on the SCSI bus, install the supplied
SCSI terminator to the remaining port
that is on the autoloader/DCA and then
tighten the screws.
Attach the other end of the SCSI cable
to the SCSI host adapter card.
Power back on any peripheral devices
that you powered off in Step b.
Double-stacked SCSI connector
Note: Do not power on the host comput-
er at this time. You must configure the
autoloader for SCSI and Ethernet prior to
powering on the host.
15
5
Make the SCSI
connection
Caution
When installing cables, be careful not to
damage the SCSI pins on the connectors.
Damaged pins will cause the connection
to fail.
If the host computer is connected to a
network, check with the system adminis-
trator before turning off power.
Properly power off all peripheral devices
connected to the host computer.
Power off the host computer.
Install the supplied 68-pin SCSI cable to
the double-stacked SCSI connector that is
on the back of the autoloader/DCA and
tighten the screws. You can install the
SCSI cable in either port.
Note: Notice that the connector on the
end of the cable is offset. Make sure that
you install it with the correct orientation
so that you can fit a terminator or anoth-
er cable in the other port.
!
d
a
b
c
Sections 5-9 explain
how to set up the
autoloader.
14