Tandberg Data Magnum 224, Инструкция по эксплуатации

Страница: 8 / 12

8
OF
12
3.
3. 3.
3. Installing the new tape drive —
a. a. a. a. Library connectors—Locate the serial cable (
S
) that came in your replacement kit and attach it to the
appropriate serial connector inside the library (see Figure 1 on page 3 ) .
Full height tape drive—see Figure 2 on page 4
Half height tape drive—see Figure 3 on page 4
b. b. b. b. While holding the cables out of the way, slide the new tape drive into the library, leaving it a short distance
out to access the cables. Use care not to damage the cables.
c. c. c. c. Tape drive connectors—Connect the supplied serial cable (
S
) and the power cable (
P
) to the tape drives .
Full Height tape drive cable connections—
Serial —Route the serial cable (
S
) under the tape drive carrier and connect as shown in Figure 2 on page 4 .
Power —Route the power cable (
P
) through the tape drive carriers and connect as shown in Figure 4 on
page 4 .
Half Height tape drive cable connections—
Serial —Route the serial cable (
S
) over the tape drive carrier and under the power cable (see Figure 8 on page
6 ) and connect as shown in Figure 3 on page 4 .
Power —Route the power cable (
P
) through the tape drive carriers and connect as shown in Figure 5 on
page 4 .
d. d. d. d. Slide the tape drive the remaining distance into the library. Use care not to damage the cables during this
step.
4. 4. 4. 4. Completing the installation —
a.
a. a.
a. Attach the SCSI cover plate and the tape drive cover plate that came with your replacement kit. See “Tape
Drive Cover Plates and Serial Cable” on page 3 .
b.
b. b.
b. Reconfigure your library— You must reconfigure your library for your backup application to recognize
the new tape drive . See page 10 for instructions.
Tape drive Quantity Install in this opening... Serial connector Internal label
Full height Single tape drive Bottom Bottom Drive 1
Half height
Second tape drive Top Top Drive 2
Single tape drive Bottom Bottom Drive 1
! Important
The library requires both the SCSI cover plates and the tape drive cover plates for
ESD protection. Do not leave any openings uncovered.
Do not connect the SCSI cables until after you reconfigure the library.