Tandberg Data Magnum 224, Инструкция по эксплуатации

Страница: 10 / 12

10
OF
12
Serial —Route the serial cable (
S
) under the tape drive carrier and connect as shown in Figure 2 on page 4 .
Power —Route the power cable (
P
) through the tape drive carriers and connect as shown in Figure 4 on
page 4 .
d. d. d. d. Slide the tape drive the remaining distance into the library.
4.
4. 4.
4. Completing the installation —
a. a. a. a. Attach the SCSI cover plates and the tape drive cover plate that came with your replacement kit. See “Tape
Drive Cover Plates and Serial Cable” on page 3 .
b. b. b. b. Reconfigure your library— You must reconfigure your library for your backup application to recognize
the new tape drive . See page 10 (below) for instructions.
R
ECONFIGURING THE
L
IBRARY AND
R
ESUMING
O
PERATION
R
ECONFIGURING THE
L
IBRARY
In order for the library to recognize the new tape drive, you must set the tape drive configuration to match the
tape drives that you installed in the library.
Note: Do not connect the SCSI cables at this time.
To set tape drive configuration:
1. 1. 1. 1. At the Home screen, press Drive .
If necessary, enter the operator panel password (see the Product Manual at www.tandbergdata.com ).
2. 2. 2. 2. Press until the selection arrow ( ) points to Drive Configuration , press Select , and then press Modify .
! Important
The library requires both the SCSI cover plates and the tape drive cover plates for
ESD protection. Do not leave any openings uncovered.
Do not connect the SCSI cables until after you reconfigure the library.
Drive Drive Configuration
Drive ID 1: IBM LTO FullHigh
Interface 2: no drive
Drive Configuration
Library SCSI Bridge
Select Back Modify OK