TX7322 Addressable Sounder Base
Installation & Operation Manual
Fig.5 Connection of programming tool
and Addressable Sounder Base
Base
Base
Fig.4
Addressable Sounder Base with an upper cover or a detector
3 Addressable Sounder Base Configuration
3.1 Preparation
The TX7930 handheld programmer is used to configure the address and other parameters of the
Addressable Sounder Base. It is not included in the Addressable Sounder Bases which you purchased.
So it must be purchased separately. The programmer is packed with twin 1.5V AA battery and cable,
ready for usage once received.
It is mandatory for the commissioning personnel to have programmer tool in order to adjust the
Addressable Sounder Base conferring to the site situation and environmental requirements.
Program a unique address number for each device according to the project layout before placing
from the Terminal Base.
Warning: Disconnect the loop connection whilst connecting to the handheld programmer.
3.2 Parameter setting
1.
Connect the programming cable to Z1
and Z2 terminals, as shown in Figure 5. Press
“Power” to switch on the unit. The main
menu after the boot as shown in Figure 6.
2.
Switch-on the programmer, then press
button “3” to set encoding mode. Select
the desired encoding method and then
click the button “Write” to save the
configuration information, as shown in
Figure 7.
3.
Exit the programming tool to the main
menu and then press button “Write” or “2”
to set address. Input the desire device
address value from 1 to 254 and then press
“Write” to save the new address, as shown
in Figure 8.
4.
Exit the programming tool to the main menu and then press button “4” to set alarm sound
type. Input the desire tone type from 1 to 16 and then press “Write” to save the new tone, as
shown in Figure 9.
5.
Exit the programming tool to the main menu and then press button “Read” or “1” to view the
4050100446-Rev1.0-0917
TANDA UK
Specifications are subject to change without prior notice
6
