TX7300 Addressable Sounder Strobe
Installation & Operation Manual
4050100270-Rev1.2-0916
TANDA UK
Specifications are subject to change without prior notice
10
Figure 14
Figure 15
Figure 16
Figure 17
Figure 18
1.
Attach the programming cable to 1 and 6 Terminals of sounder strobe. Press
“Power”
to
switch-on the unit.
2.
Switch-on the programmer, then press button
“4”
to enter to
Setting
mode (Figure 14). The
programmer will display the actual configuration after few seconds.
Input the desire Tone (Table 1) then press
“Write”
to change the setting (Figure 15).
Note:
If display
“Success”,
means the entered tone is confirmed (Figure 16). If display
“Fail”,
means failure to program the tone. (Figure16) Tone 14, Tone 16 and Tone 17 are recognized
by LPCB.
3.
Press
“Exit”
key to go back Main Menu. Press
“Power”
to switch off the programmer.
3.7 Read Configuration
1.
Attach the programming cable to 1 and 6 terminals of sounder strobe. Press
“Power”
to
switch on the unit.
2.
Switch-on the programmer, then press button
“Read”
or
“1”
to enter to
Read
mode (Figure
17). The programmer will display the configuration after few seconds. (Figure 18).
1. Read
2. Write T
3. R/W Config
7
4. Set
Tone: 001
Success
Tone: 001
Fail
1. Read
2. Write T
3. R/W Config
7
4. Set
Address: 123,124
Tone: 008
ID: 123456789012
Read Description
Address
: Unique number
assigned
Note: Single address displays
one address while dual
addresses display two
addresses
Tone
: selected audible tone
ID
: Device serial number
