TX7110 Intelligent Heat Detector
Installation & Operation Manual
4050100263-Rev1.4-0916
TANDA UK
Specifications are subject to change without prior notice
5
2 Installation
2.1 Installation Preparation
This detector must be installed, commissioned and maintained by a qualified or factory trained
service personnel. The installation must be installed in compliance with all local codes having a
jurisdiction in your area or BS 5839 Part 1 and EN54.
The TX7110 heat detector has two conditions, fixed and rate of rise temperature. When power on,
both conditions are working until the sensing element satisfies on one of the condition, the detector
goes to alarm. The fixed temperature has a sensing element fixed at a specific temperature, and
when it reached, the detector activates. The rate of rise temperature heat detector will response to
a sudden increase in temperature, this makes ideal for areas where smoke detector is unsuitable.
2.2 Installation and Wiring
1.
Mount the T&A standard base on standard one [1] gang
electrical back box. Do not over-tighten the screws otherwise
the base will twist. Use M4 standard screws.
2.
Connect the wire in terminal as shown in Figure two [2]. Verify
the device number or other device parameters if desired using
handheld programmer then stick on the label before
attaching detector. The sticker labels are available on the
control panel.
3.
Attach the detector to the base, point the detector in the
base by the mark-line and secure the detector in that position
by rotating it clockwise, until it reaches the next mark line.
4.
Do not remove the red plastic dust cover until the final
handover is done.
5.
The connecting line of remote indicator should be less than 30
meters.
Terminal Description
1
Signal In (+)
2
Signal Out (+)
3
Remote Indicator (+)
4
Remote Indicator (+)
5
Signal In (-)
6
Signal Out (-)
7
Remote Indicator (-)
8
Remote Indicator (-)
Figure 2
Figure 1
Содержание TX7110
Страница 1: ......
