Tanco Autowrap 1814, Руководство оператора

Страница: 46 / 146

Tanco Autowrap -
Operator’s Manual
45
11. MAINTENANCE
Periodic Maintenance
Bearings
All pivot points are fitted with bushes and require regular greasing. Particularly those which are regularly articulating such as all pivot points are the load arm, rocking rollers, discharge
conveyor and cut and starts. These should be grease daily. The ball-bearings on the rocking rollers and the dispensers are packed with grease, and do not need any more maintenance.
Film Dispenser
If the machine is in daily use, the Gears under the plastic cover on the dispenser should be greased when needed.
Cutter / Film Holder
The cutter / film holder is pre-adjusted from the factory and does not need further adjustments. When replacing spare parts, it is necessary to adjust it.
The springs for the U-shaped slot shall be adjusted so that there is 8 - 10mm of bolt exposed below the plate.
Cleaning
The machine should be cleaned and oiled regularly during and at the end of the wrapping season.
When using high pressure washing apparatus, care must be taken with the electrical installation.
Also make sure that water is not sprayed directly into the bearings, etc..
Keep the control box protected from rain and water. If necessary use compressed air to dry electrical components.
Hydraulic Cylinders
Make sure that all hydraulic cylinders are closed or the exposed cylinder rod is covered in grease when storing the machine.
Quick Couplers
Ensure that the quick couplers are kept clean and apply the dust caps after use.
Storage
The machine should be parked on a dry place during the closed season.
Oil Filter
The oil filter must be changed once a year.