Tanco Autowrap 1814, Руководство оператора

Страница: 29 / 146

Tanco Autowrap -
Operator’s Manual
28
Operating Instructions
We shall now go through a complete wrapping process, from loading to unloading, and explain the practical use of Tanco 1814.
Fitting a roll of film.
Loading (LA Model only)
For the first bale, ensure that the rollers are set the correct width for the bale size. The dispensers should be in the park position close to the film cut & start. Ensuring you have enough
room around the machine, lower the conveyors (remove parking bracket first) and lower the load arm.
Note: that the machine overhangs on both sides the tractor when it is folded out. This requires care from the operator not to damage other bales or objects in the field.
With the Controller in N mode, Drive into the bale and squeeze it by pressing load squeeze in button on the hand-controller. Then press load arm up button to raise the load arm close to
the rocking rollers. Release the bale by pressing the load squeeze out button. Then lower the load arm to again by pressing the load arm down button.
This sequence can be done automatically by pressing L5 if the controller is configured to operate in this way see section 7.0. However this may not be suitable the oil flow from the trac-
tor varies.
Setting up the rocking rollers
The width between the rocking rollers can be adjusted by changing the position of the width stop pins and moving in and out the Left hand rocking roller frame.
This is done on a separate service using the tractors spool valve.
For smaller bale move rocking rollers closer together and for larger ones move them apart. (See Fig 8.1).
There are also rocking roller stops mounted on the rocking roller frames.
These limit the drop of the rocking roller frames and do not need to be adjusted in general.
Warning
There is a risk of crushing fingers and limbs when adjusting the rocking rollers!
The Bale should rotate smoothly; no ‘tumbling’ should be evident.
If this occurs adjust one of the roller sets out one hole at a time.
The rollers should always run parallel to one another.
Fig. 8.1 Recommended rocking roller width positions.
8. OPERATIONAL FEATURES