14
Tanco Autowrap 1300 EH
Operator’s manual
5.0
EMERGENCY STOP*.
5.1
The machine is equipped with a safety guard on the wrapping arm, and its operation must be tested
before work itself is started.
5.2
The emergency stop* is to prevent the wrapping arm from damaging people and objects, when the
machine is started and during the wrapping process.
5.3
It consists of a releaser hoop that activates a small electric switch, which gives a signal to the
control box to start the emergency stop.
5.4
When testing this function, start the wrapping arm. Hold out an arm or any obstacle. The wrapping
arm shall now stop before it hits the arm. Great care must be taken when testing this function.
5.5
To restart the machine the obstacle must be removed and the arm must be returned to its original
position. The switch on the control box (1300 M) must be turned back to the zero position. The wrapping
may start again.
5.6 IMPORTANT: GIVEN THE VELOCITY AND MOMENTUM OF THE ARM IT IS IMPOSSIBLE TO STOP
THE WRAP ARM IMMEDIATELY. THE EMERGENCY STOP ARM IS PROVIDED TO HELP REDUCE
THE RISK OF SERIOUS INJURY AND GREAT CARE MUST BE TAKEN WHEN OPERATING THIS
MACHINE.
6.0
MOUNTING OF PLASTIC FILM.
§
When loading a plastic roll, first ensure the top cone (2) is pushed up to latched position, then push back
the Stretch rollers (3) until held in position by locking catch (4). .
§
Place the Roll on the Bottom Cone and release the top latch (1). Beware of Fingers!
§
Pull the film between the rollers on the pre-stretcher in the direction of the arrow. (See fig. 5-2). (See also the
sticker on the dispenser).
§
Release the locking catch and allow the rollers to lie against the roll of film. Pull the film from the roll and tie
it to the bale.
Fig.: 10-1
Fig.: 10-2