TAMS S88-Booster, Руководство пользователя

Страница: 14 / 23

English S88-2
Page 30
!
!
power. In the worst case the whole circuit can be damaged, and at the
best, a wrongly connected part will not function.
Next solder the terminal strips and the solder pins. Join the terminal
strips together before soldering.
Finally, insert the ICs into the soldered IC-sockets.
Caution:
Do not touch the ICs without first discharging yourself by touching a
radiator or other grounded metal parts. Do not bend the "legs" of the
ICs when inserting them into the sockets. Check that the markings on
the PCB, the socket and the IC are in the same direction.
Performing a visual check
Due to material defects and / or improper assembly there may be risks
of injury. Transport damage to ready-built modules is also possible. So
you must perform a visual check after the assembly or after unpacking
the module.
Caution:
Do not power up the module yet.
The following points are inapplicable if you have purchased a ready-
built module.
§
Remove all loose parts, wire ends or drops of solder from the PCB.
Remove all sharp wire ends.
§
Check that solder contacts which are close to each other are not
unintentionally connected to each other. Risk of short circuit!
§
Check that all components are polarised correctly.
When you have remedied all faults, go on to the next part.