English
LD-G-2
Page 24
2. Setting the driving characteristics - step 2
During this programming step the locomotive continuously accelerates
and brakes. Advice: The settings you make in the programming step 2
are valid for both velocity characteristics.
Setting the automatic shuttle service:
Set if the automatic shuttle
service is to be active or not in later operation.
Shuttle servie in later operation active: Function F3 on.
Shuttle servie in later operation active: Function F3 off.
When the automatic shuttle service is activated the locomotive changes
the direction of travel after the next braking operation and keeps up the
shuttle service during the whole programming step.
Setting the brake delay:
Switch off the auxiliary function F1. The
locomotive accelerates with the acceleration delay set in state of
delivery or in a former programming. Then it brakes with the brake
delay set at the speed knob. You may modify the brake delay by
operating the speed knob. Speed level 0 corresponds to no brake delay,
speed level 14 (250 on the Märklin* Control unit) to maximum brake
delay. As soon as the brake delay is set as desired you have to confirm
your setting by switching the function key „function“ on and off once.
Setting the acceleration delay:
Now switch on the auxiliary function
F1. The locomotive accelerates with the acceleration delay set at the
speed knob and then brakes with the brake delay set before. Continue
as described in section: „Setting the brake delay“. As soon as the
acceleration delay is set as desired you have to confirm your setting by
switching the function key „function“ on and off once.
During this programming step you may switch the automatic shuttle
service on or off as required by operating F3 and also change between
setting the brake or the acceleration delay by operating F1.
When all settings are made, you close the programming mode by
disconnecting the decoder (pushing the button „stop“ or taking the
locomotive from the track).